Hamilton Heater Cooler on Prep Welcome Packet

So Hot It’s Cool Hamilton Heater Cooler installation instructions for Prep

Hamilton Heater Cooler Installation Instructions

Please start your Hamilton Heater Cooler (HHC) installation at the section that best suits your installation status.

Section 1: Installing an HHC on a New Prep.............................. 4

Section 2: Upgrading an Existing Prep with an HHC............... 10

SECTION 1:

INSTALLING AN HHC ON A NEW PREP

1

2

Unpack and begin installing the Prep, following the instructions in the Prep Welcome Packet (A). The instructions will indicate to install the HHC at Step 20 ; return to these instructions at that point.

Ducts, screws, and a screwdriver are included in the HHC box. The duct and cover must be carefully installed on the correct sides as shown.

A

If installing an HHC adapter, visit hamiltoncompany.com/prephelp

SECTION 1: INSTALLING AN HHC ON A NEW PREP

Remove the rubber plug shown in red by pulling on one of the tabs. 3

Place the HHC in the back- left corner of the deck area. 4

SECTION 1: INSTALLING AN HHC ON A NEW PREP

5

Secure the power/ communication cable using the cable bracket and included screw. 6

Attach the HHC to the Prep using a 3 mm hex wrench and one of the included screws. The Prep comes with a set of hex wrenches for installation and maintenance. The HHC will sit completely flat when correctly installed.

SECTION 1: INSTALLING AN HHC ON A NEW PREP

Unscrew the accessory port cover and screw in the HHC cable. Make sure the cable is attached tightly. 7

Resume Prep installation at Step 22 in the Prep welcome packet (A). 8

A

SECTION 2: UPGRADING AN EXISTING PREP WITH AN HHC

Power off the Prep and disconnect the power cable. Connecting an HHC to a Prep while powered on can result in damage to both devices. 1

Remove the 8-site deck and set it aside. Store the old deck in a safe location. 2

SECTION 2: UPGRADING AN EXISTING PREP WITH AN HHC

Remove the rubber plug shown in red by pulling on one of the tabs. 3

4

Ducts, screws, and a screwdriver are included in the HHC box. The duct and cover must be carefully installed on the correct sides as shown.

If installing an HHC adapter, visit hamiltoncompany.com/prephelp

SECTION 2: UPGRADING AN EXISTING PREP WITH AN HHC

Place the HHC in the back- left corner of the deck area. The HHC will sit completely flat when correctly installed. 5

Attach the HHC to the Prep using a 3 mm hex wrench and one of the included screws. The Prep comes with a set of hex wrenches for installation and maintenance. 6

SECTION 2: UPGRADING AN EXISTING PREP WITH AN HHC

Secure the power/ communication cable using the cable bracket and included screw. 7

Unscrew the accessory port cover and screw in the HHC cable. Ensure the cable is attached tightly. 8

SECTION 2: UPGRADING AN EXISTING PREP WITH AN HHC

9

10

D

Install the 7-site deck:

Plug in and power on the Prep. Confirm that the HHC is connected:

A. R emove the deck and base plates

from their packaging.

A. Sign in, if prompted.

B. P lace the deck frame on the Prep. The sites numbered 4 and 8 should be at the front.

B. Tap “New Protocol”

C. Select either “Detect” or “Add” on the Place Labware page. D. C onfirm that site 1, the back-left site, is grayed out and says

C. Install the base plates

for each site. Press down on each plate to ensure they are secure.

4 8

“HHC.” If the HHC does not appear, contact Hamilton support.

Hamilton is here for you! Visit HamiltonCompany.com/PrepHelp to browse our online help center or file a ticket.

©2023 Hamilton Company. All rights reserved. All other trademarks are owned and/or registered by Hamilton Company in the U.S. and/or other countries. Lit No: BR-2309-11 v.1.0 — 12/2023

United States +1-775-858-3000 United Kingdom, Ireland +44 (0) 121 272 92 80 Brazil +55 (11) 126 50562 China +86 21 6164 6567 France +33 184 008 420 Italy +39 39 689 33 93

Japan +81 3 6435 6850 Spain, Portugal +34 930 186 262 Denmark, Norway, Sweden, Finland +46 (0) 8 410 273 73 Germany, Switzerland, Austria, Benelux +49 (089) 248 804 808

To find a subsidiary or distributor in your area, please visit, www.hamiltoncompany.com/contacts.

Web: www.hamiltoncompany.com/robotics Email: marketingrequest@hamiltoncompany.com

Page 1 Page 2-3 Page 4-5 Page 6-7 Page 8-9 Page 10-11 Page 12-13 Page 14-15 Page 16-17 Page 18-19 Page 20-21 Page 22

Powered by